6 points to choose a chiller

1. Determine your own ice volume, according to the scale and development plan, determine the amount of ice machine model based on it, if you buy a larger model machine is a waste of resources, if you use a small model of the machine, there is not enough ice; In general, the room temperature is calculated by the cooler marking rate (15 ° C Inuit room temperature, water temperature 10 ° C), because the high temperature of air and water in summer will reduce the production of ice by 30%, so a relatively large machine model was chosen. In addition, because there is no unified standard, the domestic water dispenser industry, some brands of ice production and labeling are very different from the actual ice production, you look at the refrigeration capacity of the compressor and evaporator to know its size.

2, the appearance of the material machine is crucial, for 201, 202 and other stainless steel iron will rust over time, and is very difficult to clean and hygienic, cosmetic and corrosion resistant stainless steel 304. 304 stainless steel has always insisted that other materials do not reduce the cost of replacing stainless steel can not detect any ferromagnets, authorities must be identified, and chemical solutions can be easily identified.

3. To a large extent, depends on the quality of mechanical parts used as the main part of the compressor, expansion valve, fan, valve, defrost valve and other internationally renowned brands, not only has stable ice production, reduces the failure rate, and extends the service life of this machine.

4. If you choose the energy-saving machine, water, electricity, the annual savings are also considerable. Inuit machine design reasonable test, evaporator, compressor reasonable configuration, especially green plastic ABS, ABS made of stainless steel main frame thermal conductivity of a few percent of the thermal conduction almost block of conduction, so that 15% energy savings.

5. Intelligent design, will use cooler microcomputer control, automatic ice machine. A greater improvement in the cooler is based not only on complete automation, but also on the front panel display, which displays images during ice making, ice control, faulty display size, and easier operation.

6. For brand machine, brand machine and thoughtful after-sales service, the best choice for stable quality; There are ice types, square ice, cylindrical, crescent ice, etc. in the market a square one, which should be self-selected according to the needs of customers; Also consider the size of the indoor space, if the space is too small, not only the location to consider, but also the heat dissipation EDM, preferably using water-cooled heat dissipation parts or outdoor splitting.